understanding more about drive-in racking

In companies and other locations that keep a lot of the same sorts of goods, the unconventional Drive Stacking Malaysia is frequently utilized. Rack Supplier Malaysia provides dense storage in a compact footprint, taking up as much as 85% of the available space on the ground.

Racking systems’ appearance and feel can be affected.

The drive-in racking style is denser and more space-effective than typical broad aisle pallet racking. There are several deep parallel running lanes inside the cube-shaped building, however, there isn’t an access aisle in the middle. The sole necessary aisle will run the length of the building’s front. This will ensure that all tracks are open for traffic. In that they are wide, high, and devoid of horizontal beams that may obscure the view among vertical supports, the lanes resemble channels. Thus, the standard pallet organizing system that is frequently used in warehouses and drive-in racking is different from one another. Pallet shelves made of horizontal beams are used in the traditional technique to store pallets. In contrast, drive-in racking stores containers flat on the ground. Pallets are kept on rails attached to the posts that run along each lane rather than being placed directly on the ground.

What is the drive-in racking process?

Drive-in rails hold the pallet on both sides, giving the whole thing a ledge-like appearance. The driver of a lift truck maneuvers the vehicle towards the loading lane and loads a pallet onto the supports of the truck. Pallets are piled in a straight line from back to front and from bottom to top. Although the drive-in stacking system follows the FILO concept, FIFO may be used by constructing an entrance lane on a separate side of the structure. In these lanes, which would be parallel to one another, pallets would be loaded and retrieved. Drive-through stacking is a good choice for perishables because it allows for large amounts of storage and has the added advantage of facilitating stock rotation, even if adding an aisle limits the amount of space that is available.

Drive-In Installation of Racking Components 


The vertical uprights of a Radio Shuttle Racking System have bracing at the highest point and are supported by tie beams that run horizontally to form the lanes. The building is supported by bolted foundation plates, while guide rails added at ground level shield the lanes from forklift truck accidents. Pallet rails are fastened to the posts and extend the whole length of every lane, parallel to the orientation rails. Rails that support the pallets themselves are supported by brackets, which in turn support the rails. To prevent unintentional accidents between the operator and the pallets during the load, pallet guides are fastened to the top of the conveyor rails. Pallet stops fitted at the top and bottom of the rails keep the pallets from riskily hanging over the rear of the tracks.